Tamiya Japan – XB Fairlady Z Version Nismo (TT01 Type-E Chassis)

The spirit of black body where light illumination glows

In fair ready Z which loads 3.5 liter V type 6 cylinder engine which 2007 January, receives 2nd minor change and shows 313 horsepower, it is the completion electromotive radio control car of the version NISMO which joins as a top model of running. The aerodynamic forum which NISMO which takes charge of the NISSAN race/lace section finishes reality as for the body which it reappears fully, being lightweight, the polycarbonate make which is strong in the shock. The headlight 2 light (white), the tail lamp 2 light (the lead-lead) LED is installed and can enjoy light/write illumination. Of course, to assemble the body and be completed, also the transmitter of wheel type, the battery and the charger for travelling to be set, running is possible directly.

Controller bull shaft 4WD chassis, TT-01 TYPE-E adoption

As for chassis, TT-01 TYPE-E of vertical ranging motor [shiyahutodoraibu] 4WD. In the mainframe of bathtub type, equipping the upper deck and the gear cover of the fiberglass strengthening nylon resin, make it guaranteed high chassis rigidity. As for the steering system play to be little 3 division types of movement which is smooth. Low going hand in hand with the center of gravity good balance design and 4 wheel double wishbone suspension and the diff. gear etc which is equipped on front and back, the controller bull showing flight quality. In addition, both moving back and forth ESC and [tamiya] TEU-101BK whose smooth control is possible were loaded.

Basic specifications

- Total length 435mm, full-width 190mm and total height 140mm　- Wheel base 257mm　- Tire width/diameter also =FR 27/67mm　- Frame = bathtub type　- Drive system = vertical ranging motor [shiyahutodoraibuhurutaimu] 4WD　- Also diff. gear = front and back 3 bevels　- Steering wheel =3 divided tie rod system　- Suspension =4 wheel double wishbone　- Also damper = front and back friction　- Gear ratio =8.35: 1 ●540 type motor attachments　- [tamiya] TEU-101BK speed controller attachment & power source for transmitter (8 single 3 shape electric batteries) difference sale

Source : Tamiya

Tamiya Japan – Rev Storm

While making exhaust noise echo, it is the completion engine RC track/truck which can enjoy dynamic off load travelling. As for the chassis which loads the [tamiya] FS-18FD engine of aerodynamic volume displacement 3.0cc, the high rigidity which combines the resin make upper deck to 2.5mm thick aluminum alloy make [rowadetsuki], shaft drive 4WD of double deck frame adoption. As for suspension the double wishbone 4 wheel independence which is superior in road-hugging. Standard it equipped also the oil damper which absorbs the shock from the road surface pliantly. As for the body and the rear wing the polycarbonate make whose strength is high lightly. Loading the 65cc fuel tank of the choke pump attachment, it can enjoy travelling of approximately 5 parts in 1 tanks.

Tamiya – 1/10 XB PORSCHE 911 GT3 Cup VIP 2007 (TT-01 Type-E Chassis)

47th Shizuoka Hobby Show – Tamiya Nissan GT-R

1/10 RC Nissan GT-R (TT-01 Type-E Chassis) (58411)

Available : July 2008

The car and NISSAN GT-R that attracts attention most now are appearance with an electric RC car. The form that pursues aerodynamic with which a sense of existence overflows is reproduced by the polycarbonate in the round. The door mirror and Riyaspoirar are prepared with another parts. In addition, the light case before and after can enjoy the light lighting by equipping it with a plating parts and high luminance LED. The chassis drove ..Contororrabl.. control the shaft 4WD, and adopted TT-01 TYPE-E.

- 444mm in the total length. – The radial tire is installed in a real car and the spoke wheel of seven of this design (offset +2). – Chassis composition with high strength composed of bathtub frame and upper deck

Source : Tamiya

47th Shizuoka Hobby Show – Tamiya Volkswagen Golf GTI Cup Car

1/10 RC Volkswagen Golf GTI Cup Car (TT-01 Type-E Chassis) (58410)

Available July 2008

Source : Tamiya

47th Shizuoka Hobby Show – Tamiya DF-03 MS

RC Limited Edition

1/10RC DF-03 MS (49496)

Available July 2008

The option parts were fully loaded to an efficient, baggy chassis and DF-03 of shaft drive 4WD. Driving efficiency is improved further by an Assembly universal shaft, the slippers clutch, and the central one way, etc. , and the underside is tightened with the aluminum damper and the hard turnbuckle shaft. It is finishing addition in front of TRF in living color racing wing for sticker, body, and baggy.

- The heat sink bar, the light battery stopper pin, the aluminum turnbuckle steering wheel rod, and the aluminum all-in-one design propeller cup collaboration, etc. were set. – With sticker of front living color.

Source : Tamiya

47th Shizuoka Hobby Show – Tamiya F103RM

RC Limited Edition

1/10RC F103 RM (w/BODY) (84031)

Source : Tamiya

47th Shizuoka Hobby Show – Tamiya TRF416 Lower 2.5mm Deck

TRF416 Lower Deck (2.5mm Thick)

Source : Tamiya

47th Shizuoka Hobby Show – Tamiya ARTA Garaiya TB-03

1/10RC ARTA Garaiya（TB-03 CHASSIS） （58409）

Source : Tamiya

47th Shizuoka Hobby Show – Tamiya Suzuki SX4 WRC (TT-01 Type-E Chassis)

1/10RC SUZUKI SX4 WRC（TT-01 TYPE-E CHASSIS） （58408）

Source : Tamiya